Precision punching Considerations When frame mode and transfer mode

Precision punching frame mode Note:
① First select the punch for the mold, die first and then when the slider, and the debug mode must be inching, has been free due to excessive speed, punch mold damage;
② When the truck to punch table fork mold, staff to stay away from the danger zone;
③ frame mode when you want to clean up and down the template can not be a foreign body;
④ have mold handle it must first leave the handle screw fixed die punch and die handle and the handle hole appropriate size;
⑤ When moving mold, do not force too small, especially the smaller mold has been slipping Mian mold caused injury event;
⑥ erected there blanking hole of the mold, be sure to check whether the plug blanking aperture;
⑦ The mold high enough, the need to add pads, pads applied must be the same height and the same material;
⑧ For special mold to use a special method to frame, in order to avoid mold damage, mold when the mold frame as a "V" of the upper and lower mold clamping with the slider closed after the slide raised the red material thickness size;
⑨ frame member at the time of mold clamping, is standing way must be splayed feet, and do not force too much, too much force in order to avoid slipping and causing accidents occur.
Caution precision punching transfer mode when
① test mode to check whether the lock up and down mode, the mold without exception, subject to immediately improve further test mode operation;
② tryout die before understanding the function of the project's work content of what it is, pay attention to what the problem;
Jog mode must die slowly on to the next test mode when ③ dead point, and then adjust the slider to the desired height;
④ Do not under too deep for cutting, punching mold, punch holes through the material to be cut in order to avoid mold damage;
⑤ targeted letters mold, stamping die, do not air play, you need a mat produced material thickness of the product debug, until OK prevail.
⑥ tryout reverse direction when the product is not put Conversely, when the pros and cons of a product can be positioned in a mold, or you do not know how to start, especially when a project before and after the attention of several engineering coherent observational studies, such as can not please Get superior handling, do not easily tamper with;
⑦ For "V" type of mold, test mode is particularly careful attention, with the slider closed mold height will rise a material thickness;
⑧ for riveting transfer mode, the mold can not be under the same too deeply, all with the slider method transfer mode.