SAMHOOR speed presses Xiaobian for you to explain high-speed presses rack molding step

Dear friends, please read it carefully so that you make better use of high-speed presses.
SAMHOOR high-speed presses and convenient digital transfer mode systems
Step speed punch frame mode is divided into three steps:

First, high-speed presses frame molding ago:
① select the appropriate mold tonnage high-speed presses, die-height check whether the punch within the allowable range.
② high-speed presses up and down the table to clean up, not a foreign body, the bottom surface of the lower die mold may not have debris, should be flat.
③ mold punch to be placed in the middle of the table.
④ punch stroke selection jog.
Second, high-speed presses rack mold:
① When l die first slider, and then use the jog mode slowly dropped to the bottom dead center.
② have mold handle, the handle must be aligned with the handle hole mold to the lower dead point, close to the die shrink.
③ no mold handle mold, the mold is placed in a suitable location, and note that there are holes in the blanking blanking die do not block the hole.
④ pad used must be flat, and must check whether the force balance, and pay attention not blocking materials to prevent blocking material leaving the mold damage.
⑤ mold can be tightened on the mold, and then punched into the waste material thickness required, use the slider to adjust to the proper height of the closing, and air play two or three times, and then lock the lower mold.
When ⑥ V-type mold rack will be closed after the upper and lower mold clamping slider, slider increased material thickness dimensions of the punch.
Third, high-speed presses frame mode after:
① Check whether the upper and lower mold locking.
② Check whether the upper and lower mold anomalies.
③ tools in place, clean up the site.