How to adjust the height of the high-speed punch slider closure

The combined upper and lower molds 1. Die high-speed presses, and then measure the height of the mold; the high-speed punch slider quenched lower dead point, measure the distance to the high speed punch slider work surface, adjust the slider screw the slider to distance high-speed presses work surface is equal to the height of the mold. After removal of the slider to adjust the height of the closure of the tail fan motor, plus a motor cover, and fitted with a small electromagnetic brake, to install high-speed punch closed height adjustment brake, after years of testing, due to the variations of the height of the slider closure never happened product quality problems.

2. Insert the punch slider to adjust the selector knob to "ON" position, then in accordance with the terms determined by the height of the press if it is too high, the charge of "slide down" button, watching "mold height indicator" adjusted to the appropriate height, release the button. If for the high-speed punch height is too low, the charge of "slide up" button and adjustment. Note, however toppings device is not normal was hit selector knob to "OFF" and then use Jog operation, the slider row top dead center position. Slider to adjust the electrical circuit is energized, the operating circuit to even turn off state, even when the transfer operation circuit is energized, the slider to adjust the lifting operation is invalid.