——“Samhoor nicety machine”it began in 2000 year,focus on Precision punching, high-speed presses production stamping equipment R & D .
Dedicated, professional, quality !
Installation of high-speed presses the main motor, high speed and precautions
High-speed presses the main motor is an electromagnetic induction equipment, the use of electrical energy into kinetic energy into an electromagnetic device with DC and AC divided by the stationary part, rotating part and other accessories three-phase asynchronous motor components. Main motor repair installation and adjustments to be extra attention, so as not to cause damage to the internal parts.
First, install the main motor speed punch
1, high-speed presses disassembled parts packaging and check for damage.
2, high-speed presses to clean the motor, the motor sheave, flywheel groove, clamp block, do not drop the solution in the motor with a cloth to clean V belts, prohibit the use of belt cleaning solution.
3, install high-speed presses to engage the motor position, but do not completely locked in before the screws are not locked with a sling to support the weight of the motor.
4, measured by measuring the motor speed punch sheave alignment with the flywheel, the motor to move the alignment correct. Sheave and pulley alignment did not make for a good groove belt and motor bearing wear, good alignment of the motor housing when tightening the screw.
5, shift motor slightly to the flywheel so that V belt pulley can slide without becoming strained.
Installation Note: Do not use force on the belt installation sheave grooves. Belt tightness best to thumb under pressure after installing 1/2 "left and right prevail. Improper installation can cause the motor does not start after powered motor speed slow and weak, the motor housing charged, the motor is running temperature increased, the motor running noise big, body overheating phenomena.
Second, the main motor speed punch level adjustment steps:
1, first thoroughly clean the high-speed presses rack to increase the level of accuracy of readings.
2. Place a rack in the leading edge of a level of precision, as before, three measurements after.
3. If the measured before and after a lower edge, can be used to adjust the speed punch shock foot rack bottom, right and left perfectly level.
Third, the main motor speed punch level adjustment:
1, the foot shock and high-speed presses at least as large as the foot, the foot contact surface which average bear weight.
2, in order to prevent a panacea, one month should retest their level. (In the event of an error can be a little adjustment screw to base level), other checked every six months to confirm the level of high-speed presses, and so on high-speed presses to maintain performance results are obvious.