Clutch problems on high-speed presses and Processing

The operator after pressing the clutch speed presses a button or foot switch is depressed, the clutch found no response, the majority of which is due to faulty clutch, in order to ensure high-speed presses to work properly, the need for timely repair process. Then, press the clutch to start the reaction is not how it happened?
In general, common causes and treatment of high-speed presses the clutch did not respond are:
 
1, the rotation of the key tension spring broken or loose, for this injury is only the replacement of the tension spring failure to solve the problem.
2, the rotation of the rear link at the bond breaking, breaking the tail If you turn the key, the key will fail to rotate, so cause failure of the clutch. The solution: Replace the key tail.
3, turn the key completely damaged. Solution is: replacement of key rotation. Such damage is most severe, so high-speed presses at work must be idle before the test, or likely to cause safety faults.
4, because part of the circuit, the circuit break, short circuit, loose joints, the same circuit can cause unable to connect and affect the operation of the clutch effect. Solution: Check the circuit once, for this failure can be prevented, in the course of routine maintenance and upkeep can troubleshoot this by periodically checking method.
5, no foot switch plug into the socket, if the plug is not inserted in the socket, the switch will be no stampede effect. Solution to: check whether inserted into the socket, if not, into the socket.
 
A final note: if the operator when operating the high-speed presses clutch found intense impulse phenomenon, which is due to brake too loose, or the clutch gear damage. Solution: If the brake is reason to adjust the tightness of the brake can be solved, if the gear is damaged, only the replacement of the gear can be resolved.