——“Samhoor nicety machine”it began in 2000 year,focus on Precision punching, high-speed presses production stamping equipment R & D .
Dedicated, professional, quality !
Simply widely failure of two high-speed presses
Simply put two high-speed presses widely fault, and tell you what should be ruled out and deal with these issues.
1, pipe leakage.
This occurs, it is generally not seal quality, pour into the tube leak. This occurs, users do not despise, after which no outflow will flow inside the mold, a great impact on the high-speed mode, do not listen to some manufacturers salespeople nonsense, this lubricating oil can not die, not with this oil No. Like, is not the same size, of the mold have 100 victims without a profit. Immediately contact the manufacturer of high-speed presses, to make the replacement of seals.
2, steel scratches.
This happens, no one is polished copper sleeve good, two is poor quality steel, electroplating problems, steel hardness is not enough, after scratches, spills will occur is like this situation, if a little serious, then only replace the pipe.