SAMHOOR high-speed punch ─ provide the most complete after-sales service for the maintenance of punch machinery

Question: I want to ask why the high-speed mechanical punching machine has been used for several days. It often happens that there is a curved scimitar under the flywheel that will jam the clutch that rotates the flywheel at high speed. In this way it will not be able to drive the flywheel and will become mechanical. Can't move up and down normally? Is this a problem with the flywheel? Or is it not always the result of adding lubricant? How can I improve this situation? This is an old problem, and I am often troubled by it. I hope someone can answer this question? thank you very much! !

 

Answer: It will get stuck. 1 Lack of lubricant. 2 Close the spring that pushes the card to the side of the blade to make it tired. Replace it (remove it and buy one with the same specifications at the hardware store)

 

SAMHOOR high-speed punch ─ provide the most complete after-sales service

If the parts of SAMHOOR high-speed punching machine are faulty, please contact [SAMHOOR high-speed punching machine manufacturer]. We all provide mechanical after-sales service. You are welcome to contact the maintenance team of our factory. If the flywheel in the high-speed punching machine encounters the above problems. For operational issues, we still recommend that you contact us. In many cases, the operation will get stuck. It may be caused by environmental factors, such as: the environment is too humid, the machine is overheated, but it may also be caused by human factors. There may be many reasons for machine maintenance or fatigue caused by the consumption of springs in the machine!

 

Therefore, if the punching machine is not running smoothly, please call [SAMHOOR high-speed punching machine manufacturer] to contact us. We can check the cause of the mechanical failure in detail for you and propose remedial measures so that the machine can immediately restore the original operating function!