Automatic high-speed punch punching terminals or feeder structure and working principle
Changer terminal or feeder is designed for high-speed punch press machine with a single terminal to receive double strip band. A high-end receipts device having superior performance, high efficiency, time-saving advantages. When a full income, will automatically switch to the other tray to continue working. Middle without stopping, high-speed presses automatic rewinding machine is the most advanced automation equipment receipts.

Here's what works automatic high-speed presses rewinding machines
The tape drawn from the punch by photoelectric eye, artificial feeding into the wheel, the wheel cylinder pressure starts after pressing the strip, adjust the guide rail material. Start feeding motor, the material is fed into the terminal block through the guide chute. At this time, receiving the motor has been started, the disk rotation drive terminal, the tape is also wound on the terminal board. When the tape reaches the terminal block namely the tape wound on the terminal board. In this case the feed motor to stop feeding.
Nip wheel cylinder relax by the receipt tape disk drive charge. In the photoelectric switch control start receipts. Counter start number to remember. When the preset value over mind, rewinding motor stops. Cutting cylinder moves the terminal tape cutting.
Receipts motor continues to rotate in a circle, will be expected to end late to stop the material involved. Receipts motor cylinder moves, the motor is disengaged receipt receipt tray. In the pilot chute guide trough servo motor operation reset, leaving the receipt tray. Elevating motor starts work. After receipt tray rose to a suitable location, start the motor rewinding, rewinding disc begins to turn. Guide chute under the action of a motor servo swing to the working position. In this case, feed rollers start feeding. Clamping nip round the terminal strip material into the closed trays. In this case, manually received full video disc is removed, rewound the tape good waiting for the second cycle.
The above procedures are pre-configured, operation, open interface, enter the desired adjustment value. Open automatically, you can automatically complete a series of automatic rewinding action.