How to confirm whether the high-speed presses status is normal?
Before using the high-speed presses, the staff should first confirm whether the next machine is normal, and only in the normal state of the premise, in order to ensure high-speed presses to work properly. So, how to verify the status of high-speed presses normal?

Please confirm the contents before operating the following aspects:
1, the carrying capacity of red
High-speed presses operating pressure must be lower than the rated pressure. If the pressure is too large, you need to install the hydraulic overload protection device, which can prevent punching failure safety device, so before, you need to calculate the carrying capacity of a good punch machine. Punching operation for a long period of time, it is best to keep the use of less than 70% capacity, so that only mechanical life.
2, stamping capacity
High-speed punch presses and stamping stroke stroke curve of a relationship, not to say an arbitrary position of the slider can be reached, in general, how much are dead before your reach, you can view the factory comes with specific instructions. According to the position of the punching stroke "curve" the ability to use a perforated tonnage stamping ability to work must be smaller than the normal parameters, otherwise it will cause damage to the clutch.
3, the energy capacity
Energy at every stage of the energy consumption during the release of energy and motion of the flywheel according to the weekly balance measurements, if the operation beyond the capabilities of a long time, it will produce electric electromechanical easy to hop phenomenon, in order to prevent accidents, must be carried out at less than rated conditions work, so as to meet the requirements of the job.