High-speed presses start-stop button failure causes and treatment methods:
 
1, high-speed presses the switch circuit have decay or break situation, you can exchange a new two-division punch line and tighten the screws.
2, two degrees off the produce, the second time will fall eliminated.
3, the speed is about zero, if the speed control knob to view the minimum, identify the cause, so that the speed of recovery.
4, insufficient air pressure, check whether the high-speed punch line or inadequate air pressure leakage performance, and replace them.
5, overload assembly is not reset, it is necessary to press the reset after overload protection can be.
6, the slider switch means changes to "ON" place, it will be cut to "OFF" can be.
 
And that led to the failure of high-speed presses start-stop button causes and treatment methods introduction, I hope you can help solve this problem,