On high speed press tonnage monitor correction and the main function

High speed press tonnage monitor correction:

The tonnage of sensors installed on the high-speed punching machine, in case is only part of the wiring, shows the load value is not the actual strength of stamping, if you want to display the correct stamping, must use after installation ends corrector and weighing sensor calibration. Calibration using the load when the yuan (load cell) or jack do actual stamping test, through actual measured load or jack tonnage again and compare the tonnage monitor calibration, to ensure the accuracy of tonnage monitor.

High speed press tonnage monitor main function is introduced:

 A. tonnage display shows the current load: tonnage, high speed stamping punch actual strength can be mastered, and any one channel the load exceeds the set value, will be issued a stop signal and stop the machine.

B. overload detector set the maximum punch load, when a punch press the maximum load will produce abrupt stop, avoid overload causes the damage of punch and die.

C. monitor punch load stability: in stamping products actually needs strength, set to the absolute minimum set to detect or to be inspected by comparing before and after the total load to prevent abnormal stamping, controls the stability of production quality, and through this feature allows an operator to monitor more than one punch, because when an exception occurs stamping press stop.