Heat balance control on high-speed presses lubricating and cooling system

    High-speed presses in operation, due to mutual friction of the crankshaft connecting rod between the bed rail and motor factors will generate a lot of heat, so that the temperature of the components high-speed presses, resulting in uneven thermal deformation, after the previous analysis, This will not only affect the thermal deformation of the performance parameters of high-speed presses, but also for punching, dimensional accuracy, surface quality will be greatly affected, so for high-speed presses heat balance control has a very important significance. In addition to structural improvements, the most effective way is to use good lubrication cooling system (above), in order to achieve thermal equilibrium requirements.
 
    SAMHOOR speed presses manufacturers are using the improved full oil lubrication cooling system. In this system, one is working in order to stabilize high-speed presses, the system must be from high-speed punch with enough heat, on the other hand, this in order to improve and control the emergence of precision punching change at any time thermal crown degree, the cooling system must be done according to the cooling of different intensity in different regions punch each site. And while cooling system also acts as a lubricant, high-speed presses moving parts can be reduced coefficient of friction between the surfaces in contact, so, lubrication cooling system is essential for high-speed presses an important part.