How to introduce high-speed presses and fault detection

Introduce high-speed presses:

1, high-strength cast iron bed, the internal stress relief, so that the material is stable, the same precision, the most suitable for stamping Health

2, double guide column, a central pillar structure, using a special alloy of copper was added to replace the traditional slide sleeve structure, the dynamic friction to a minimum, with a forced lubrication to minimize the thermal deformation and highest precision.

3, optional reverse side balancing device to reduce vibration, so punch with the best accuracy and stability.

4, manual adjustment mode, with the die height meter and hydraulic locking device to facilitate transfer mode operation.

5, HMI microcomputer control, numerical, fault monitoring system, the screen display for easy operation.

  High-speed presses fault detection:

1, before the first check whether it is not on high-speed presses various parts of screws loose? All were lubrication hole, and then hand plate moving revolutions (do not suddenly start) started to operate.

2, the mold must be installed in high-speed presses table center position, the upper and lower mold must be calibrated correctly, try several times before punching the mold fixing screw fastening it, during the operation should always pay attention to whether the mobile mold position? To prevent accidents caused by equipment hit the upper and lower molds.

3, we should always pay attention to the phenomenon of fastening screws loose parts and Shaw each shaft? There are electrical box of high-speed presses, should always pay attention to check the electrical lines, in particular iron absorption and rod, to maintain a good sensitive and reliable.

4, where the high-speed presses equipped with protective devices, and not to arbitrarily removed; remove mold needs as a result of the exchange, to be mold correction should immediately installed to ensure safety.

5, high-speed stamping presses must be given the man-machine, personal use, and not to others unauthorized use high-speed presses, as a result of production must, to get the consent of the custodian, must be done before using a comprehensive inspection of the high-speed presses, while familiar with the high-speed presses before using performance.

6, high-speed punch after work to do cleaning and maintenance, lubrication work, and later turn off the power, the tools, measuring tool store it. Before leaving, such as the opening of two classes shift to do detailed records.